Adjust the middle screws to remove any twist caused when the screws were tightened

Align the holes to the screws, hang the panel in place, and tighten the screws

It has no nails or screws.

Lock the leveling screws in place

He screws a little, then stops.

Loosen these screws but don't remove them

Now tighten the screws top to bottom

He moved the screws to rehang it.

Loosen the screws and remove the lamp cover.

Adjust the screws until the bubble is centered

With these screws tight, move back to the larger screws holding the upper frame in place and final tighten these

He seems like he's got a few screws loose.

This machine cranks out a thousand screws an hour.

The bottom screws open. That's great. Oh, my God.

On base castings with 6 or 8 leveling screws the middle screws should not be touching the pads during the leveling procedure

Start with the screws on the chip conveyor side followed by two of the four screws on the left side of the panel

Any adjustments from this point forward will be done with the middle screws ONLY with both middle screws adjusted the same each time

Use the hex key wrench to tighten the front screws

Leave the two screws fastened in the slots for last

Remember, only move the screws in small and equal amounts

Once the height has been set raise the center leveling screws

Carefully tighten the locking nuts while holding the leveling screws stationary

Install two additional screws on each side plate of the frame

Hang the panel by aligning the drop out holes with the screws

Next, adjust the middle leveling screws until lowered onto the leveling pucks

With the middle screws tight the remaining steps in this process are

Rotate both middle screws up to bring them completely off the middle pads

Tighten the locking nuts while holding the leveling screws so they don't rotate

Now, install the screws fastening the panel to the upper and lower enclosure frames

If a thief screws up on the job, the mob blows his fingers off.

With the twist removed, it is time to lower the middle leveling screws into position

Bring the screws to almost snug so there is some movement left in the frame

Fasten the middle and rear roof panels together and then tighten the side facing screws

Lisa is so skillful that she can even make screws and similar small objects for herself.

Each time you make an adjustment turn both leveling screws on that end an equal amount

We will adjust the B axis by raising the middle of the machine using the middle screws

Continue to adjust the leveling screws until the bubble reads zero at both ends of Z axis travel

This hardware kit contains four half thirteen screws which will be used to secure the upper enclosure frame

Remove all the screws connecting the bracket to the panel and then remove the bracket from the machine

Install screws at the top of each of the side panels in preparation for hanging the roof panel

Align the slots in the roof panel with the side panel screws and carefully drop it into place

Hang the rear panel and fasten the screws into the side panel, support frame, and roof panel holes

Adjust either the front or back screws evenly to bring the bubble to the center of the vial

Again, ONLY very small adjustments should be made to the middle screws while re measuring the level values

Only the values from front to back can be effectively changed by adjustment of the middle leveling screws