clamp to ground

Hold on to the rail.

Tom was leaning against the rail.

He was leaning against the rail.

He tried to grasp the rail.

The town is accessible by rail.

But rail at me no more!

She was as thin as a rail.

His bike ran into a guard rail.

I cross the rail tracks every morning.

After you pushed him through the rail.

Get hold of the rail just in case.

And they're coming into the city by rail.

A wise businessman knows how to clamp down on costs.

In order to clamp in the desired center of stroke

We should probably put in a rail or something.

This one says, Bucolic meadow with split rail fence.

But you clamp this thing on my head, and something happens.

There are a lot of hangers on the curtain rail.

( engine starts ) No question, he was shoved through the rail.

For example, I can make a large circular rail here.

You had rail networks that connected residential, industrial, commercial areas.

Always be sure to clamp with the jaws against the boring ring

The rail line was carried under the Tsugaru Strait to Hokkaido.

We happened to see a truck run into the guard rail.

And pretty soon, they began shipping that coal, ton by ton, rail car by rail car, boatload by boatload, back to China and elsewhere around the world.

The car crashed into the guard rail and rolled down the hill.

When we clamp this accurately machined slug at 300 psi and check for deflection

Again we clamp the machined slug at 300 psi and although you might think

The cost of the air fare is higher than of the rail fare.

James wanted to use bus rapid transport for that, rather than light rail.

One, in a hundred years, transit on all major rail and road corridors.

We clamp it at the center of the jaws leaving adequate clearance for the cutting path

Connecting the 1 2 hose directly to the hose barb, with a hose clamp, is preferred

Aluminum jaws are typically used to grip light weight or hollow parts where clamp force is low

Keep in mind that there are many situations where you will need to clamp your work piece

We need to clamp OD gripping jaws to just slightly smaller than the work piece outer diameter

When we clamp the demonstration work piece at a pressure of 400 psi, jaw deflection becomes significant

And when I place the superconducting disk on top of this rail, it moves freely.

Now supposedly, oil taxes are the third rail of American politics the no fly zone.

Janny, he said, over the rail of the cellar steps, 'tas the truth what Henfrey sez.

And later this year, the rail minister was sacked and sentenced to jail for 10 years.

It is recommended that the 1 2 hose is connected directly to the Hose Barb with a Hose Clamp

During jaw cutting, clamp the jaws with a force as close as possible to your planned part gripping force

We will use our part to set the initial position of the jaws as they clamp the boring ring