Translation of "control voltage transformer" to Japanese language:


  Dictionary English-Japanese

Control - translation : Transformer - translation : Voltage - translation :

  Examples (External sources, not reviewed)

XML Transformer
XML 変換Comment
XML Transformer
XML 変換
Configure XML Transformer
XML 変換の設定
Use the average of the Phase to Phase voltage measurements just taken and set the Transformer Tap position to match this average number
この平均の数と一致する 変圧器のタップの位置設定 T5 変圧器に移動します
Use the average of the phase to phase voltage measurements just taken and set the transformer tap position to match this average number
この平均の数を一致するようにトランスのタップ位置設定 T5 変圧器に移動します
If the values are good, make sure the Machine Circuit Breaker is in the OFF position and check that there is no voltage at the Transformer
変圧器で電圧がないことを確認 ちょうど撮影相相電圧の測定値の平均を使用します
If the values are good, make sure the machine circuit breaker is in the off position and check that there is no voltage at the transformer
トランス電圧がないことを確認 だけの相相電圧の測定の平均を使用します
It says, High Voltage. Yeah. Okay. Good.
電圧 と 下を見るな
Move to the T5 Transformer and set the Shorting Plug to the range that matches the Transformer Tap position just used
短絡プラグをちょうど使用される変圧器タップ位置と一致する範囲を設定 今 マシンのプライマリ ブレーカーのスイッチしコントロール パネルに移動し 電源 ON に押してください
Move to the T5 transformer and set the shorting plug to the range that matches the transformer tap position just used
ショート プラグだけ使用される変圧器タップ位置と一致する範囲を設定 コンピューターのプライマリ ブレーカーを オン 位置に切り替えます
Why is there a special high voltage power line?
あれがまやかしだと よく思えるわね?
But inside a standard transformer are two coils of wire.
この2つのコイルは非常に近接していて
A phillips screwdriver and a voltage sensing screwdriver or volt meter
ドライバーまたは電圧計を検出電圧 開始制御キャビネットでと特定はないです
Control, control.
コントロールするんじゃ
At the side of the machine open the control cabinet to check that the electricity supplied to the machine is balanced and that the transformer taps are set correctly
マシンに供給した電気にバランスが取れていることを確認するには コントロール キャビネットを開く 変圧器タップすることが正しく設定されています マルチメータで回路ブレーカーを使用して 受信電圧相相から確認してください
no phase to ground value should be larger than any of the phase to phase values a value that is too high likely indicates there is a bad or floating ground in the electrical service to the machine alert the customer what you found if the values are okay, switch the machine's circuit breaker to the off position and check that there is no voltage at the transformer using the average of the phase to phase voltage measurements just taken set the transformer tap position to match this average number
任意のフェーズ フェーズ値 たぶん大きすぎる値を示す 悪いまたは浮動の地面には
little solenoids that will lock it in place and get low voltage power.
これらは全て標準化でき
Move to the rear of the Machine and open the Control Cabinet to check that the electricity supplied to the Machine is balanced and that the Transformer Taps are set correctly
キャビネットにマシンを供給する電気にバランスが取れていることを確認するにはコントロールを開く 変圧器タップが正しく設定されて メイン回路ブレーカーは マルチメータを使用してください
Control
制御
Control
Controlkeyboard key name
Control
Controlcollection of article headers
Control
Control
Control
ハース コントロール
Control.
管理
Control.
管理官だ
Control.
支配
Classrooom control
Classrooom control
Control Centre
コントロール センター
Control Center
コントロールセンター
Gain Control
ゲインコントロール
Control points
コントロールポイント
Control Points
コントロールポイント
Playback Control
再生コントロール
Control Panel
コントロールパネル
Control Settings
コントロールの設定
Control points
コントロールポイント
Power Control
電源管理
Bridge control
ブリッジ制御
CardBus control
カードバス制御
Message control
メッセージ制御
CAPI Control
CAPI コントロール
Control Device
コントロールデバイス
control socket
コンソールソケット
Other, Control
その他 制御機能用記号
Control Pictures
制御文字用記号

 

Related searches : Voltage Transformer - Transformer Voltage - Control Transformer - Transformer Control - Capacitor Voltage Transformer - Capacitive Voltage Transformer - Medium Voltage Transformer - Voltage Transformer Ratio - High Voltage Transformer - Low Voltage Transformer - Voltage Control - Control Voltage - Control Power Transformer