Before attaching the Coolant Level Sensor to the Coolant Tank, check that it shows the correct

Coolant level indicator

Remove the cover from the coolant level sensor jack, insert the connector, and re install the cover cap

Before attaching the coolant level sensor to the coolant tank check that it registers the correct empty, 1 2 full, and full positions on the Current Commands page

Attach the three quarter inch Coolant Line from the Coolant Manifold to the standard Coolant Pump

Sensor

Place the standard coolant pump next and connect the 3 4 coolant line from the coolant manifold to the pump

Second, level the machine front to back and side to side to permit good coolant and chip flow

Trilinear sensor

Sensor Alarm

Sensor Resolution

Sensor Logger

Sensor Name

Sensor Browser

To clear the coolant tank

Connect the electrical cord from the standard Coolant Pump to the receptacle labeled Coolant

Sensor Logger Settings

Drop Sensor Here

Remove the cover from the Level Sensor Cable Receptacle, engage the Connector and re install the Cover Cap

Sensor exceeded critical limit

Color sequential area sensor

Color sequential linear sensor

So we have a little sensor network , networks, and little sensor nodes distributed.

Install the Coolant Tank Handle onto the Tank

And I'm going to insert a coolant command

We'll need coolant for the air support system.

One chip color area sensor

Two chip color area sensor

Three chip color area sensor

This is actually sensor firings.

Once the Coolant Tank is full operate the Coolant System to check that none of the connections just made are leaking

Move to the coolant pump area and attach the wash down hose assembly to the mounting point on the coolant manifold

You two get all the coolant you can carry.

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

It's really just a pressure sensor

Each of these has a sensor.

This is an empty space in a worksheet. Drag a sensor from the Sensor Browser and drop it here. A sensor display will appear that allows you to monitor the values of the sensor over time.

So, there are 2 print statements for the sensor over here and the sensor measurements over here.

I wanted to turn coolant on, I had forgotten it

And there is the coolant command inserted into the program

Push this button to delete the sensor.

It has just that sensor in it.

It depends a lot on the sensor.

The big difference is the Sensor Data.

Here's my postdoc Christian using a Kinect like sensor to do certain poses in front of a depth sensor.