You take a nozzle and you create 10 random variations on the nozzle.

Attach the three quarter inch Coolant Line from the Coolant Manifold to the standard Coolant Pump

Coolant level indicator

How do you design that nozzle?

Dispenser 172 chicken soup nozzle clogged.

Place the standard coolant pump next and connect the 3 4 coolant line from the coolant manifold to the pump

To clear the coolant tank

Connect the electrical cord from the standard Coolant Pump to the receptacle labeled Coolant

Hey, baby... you're sucking on the wrong nozzle.

Copy. Nozzle coming in at 73 per cent.

Before attaching the Coolant Level Sensor to the Coolant Tank, check that it shows the correct

And after 45 generations, you have this incredible nozzle.

You pump it at a high pressure through a nozzle.

No, it belongs to my boss. ( nozzle clatters ) His goat?

As you see, the nozzle is secreting pretty dense concrete.

Install the Coolant Tank Handle onto the Tank

And I'm going to insert a coolant command

We'll need coolant for the air support system.

The shower nozzle is equipped with a self cleaning system, too.

Once the Coolant Tank is full operate the Coolant System to check that none of the connections just made are leaking

Move to the coolant pump area and attach the wash down hose assembly to the mounting point on the coolant manifold

You two get all the coolant you can carry.

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

I wanted to turn coolant on, I had forgotten it

And there is the coolant command inserted into the program

And he will, or she will, calculate the optimal design of the nozzle.

And my last change, I wanted to alter a P Cool nozzle position

Take what they have. Minus the coolant which we don't need.

Maybe I forgot to turn coolant on before a particular tool

P Cool nozzle positions, so on and so forth, those changes are all captured

You can have a multi nozzle machine, that will be good for large buildings.

When all coolant pump connections are complete ask the customer to fill the coolant tank so the connections that were just made can be tested for leaks

leaving the machine clean with nothing remaining to contaminate the customer's coolant

lower end of the machine to maintain clearance to the coolant tank

Before attaching the coolant level sensor to the coolant tank check that it registers the correct empty, 1 2 full, and full positions on the Current Commands page

Tilt along this axis influences how coolant and chips drain from the lathe

First, the machine is positioned at the correct height above the coolant tank

First, the Machine is set to the correct height to clear the Coolant Tank

Now is a good time to install the Coolant Tank and its related components

Take out the coolant pump to access the middle leveling screw on this side

Make sure the machine is high enough off the ground to clear the coolant tank

Connect both coolant pump power cables as well as the power cable for the chip conveyor

The material, which is cementitious, initially concrete, is deposited through a nozzle, and the building is built layer by layer.

If you don't get emergency coolant to the fuel in the reactor, it can overheat and melt.

Remove the cover from the coolant level sensor jack, insert the connector, and re install the cover cap