I jog twice a week.

I jog before breakfast every morning.

Jog on, slide off.

I make it a rule to jog every morning.

I make it a rule to jog every morning.

I jog through Central Park every morning at 6 a.m.

I've decided to jog every morning.

We jog before breakfast every morning.

You don't jog for an audience.

I love to jog more than anything else in the world.

I love to jog more than anything else in the world.

I make it a rule to jog early in the morning.

She gave my elbow a little jog.

Jog the Z axis to home position

Hey, you wanna jog a few laps?

Since I'm already in handle jog mode I can just jog the axes and put the probe tip close to the corner that I am going to use

Remove the remote jog handle from its box

The body loses water when you jog, so I don't cry as easily.

Handle Jog is also a function within Setup mode so to begin, I'll press the HAND JOG key and I am ready to begin setting up my offsets

He quickened his pace, almost to a jog now.

The remote jog handle is now ready for use

ln the meantime, maybe this will jog your memory.

I returned to the hospital with Ludwig's records to try to jog Nordberg's memory.

I'm going to put the machine into Handle Jog mode by pressing the HAND JOG key and I want to see the work Offset page so I will press the OFFSET key

Jog the turret to the middle of X axis travel

The man next door said he goes for a jog every morning.

He made up his mind to jog in spite of his blindness.

Jog to a point very close to the face of the jaws

Handle jog the tool in Z and X until it is approximately

So I'm going to go to Handle Jog mode and toggle through the

Before we move on to the next screen, note that I can jog the machine axis without leaving the display

Jog X axis from end to end, stopping in the middle, to check X axis roll

Jog X axis to sweep the table over a distance of twenty inches (20 or 500mm)

Jog X axis to the middle of travel and Y axis to full negative travel to provide clearance

Then jog the turret along the Z axis towards the spindle getting to the end of Z travel if possible

Attach the phone cord to the jog handle and insert the connector into the phone jack in the hanger plate

If not, handle jog the B axis to adjust the table position until the indicator reads zero at both ends.

Handle jog the probe tip to a position one tenth of an inch (1 10 or 2.54mm) above and centered over the tooling ball

Jog the Z axis to bring the test indicator down to contact the table and zero the test indicator at the operator side of the table

To do this, we program a simple move going to X0 with the tool and offset we'll be using to re cut the jaws Press HAND JOG , press CRNT CMNDS

And the other cool thing is, not only can we move the camera around, we can also control time, so I can slide this jog dial here to shuttle time forward, and now we can see what a sunset on the ISS would look like, and they get one every 90 minutes.

Well, I I I I think so. I

I... I... I did.

I... I can't! I...

I I thought, well, I...