In contrast, with a standard set of soft jaws cut to grip this part

avoid the jaws of death.

This set of short steel jaws was bored to one inch deep while being held at 100 psi

The master jaws are at the center of their stroke. Now we're ready to cut these jaws Once the jaws have been cut, make a shallow groove at the bottom of the jaws

Soft jaws offer several benefits not provided by hard jaws

We will use our part to set the initial position of the jaws as they clamp the boring ring

We leave Z Starting Point set to zero so our boring cycle will start at the face of the jaws where we set our G54 offset

We're often frightened of sharks, thanks to Jaws.

We set the remaining values conservatively based on the insert we're using to cut these steel jaws

When boring OD gripping soft jaws cut the inside diameter of the jaws to the nominal work piece diameter

Undersize jaws will grip along six edges, whereas oversize jaws will grip only along the center of each jaw

Right where they need to be to cut these jaws We set the clamping pressure to 100 psi

It's also critical for the development of your jaws

Jaws holding the inside diameter of the work piece

Before we mount the jaws

Re cutting your soft jaws

When attaching the uncut jaws to the chuck always torque the jaws in place

When the soft jaws are held tight for cutting, the master jaws should be at the middle of their travel

Regardless of what kind of ID gripping jaws you are using

I'm the President of the Journalism and Women Symposium JAWS.

You can mount your jaws in a variety of positions

We learned about the fundamentals of cutting lathe soft jaws

When we made two different sets of OD gripping jaws

With our jaws checked at a clamped location of 3.935

And with our program set to cut both pockets to the nominal size, we are ready to cut our jaws Two step jaws are a good alternative to cutting two different jaw sets

As the jaws are forced outward

The master jaws at mid stroke

Before profiling the jaws we will take a small cut on the inside diameter of the jaws equal to the plug diameter

Andrew is considering whether to use standard soft jaws or pie jaws to ID grip this part

It looks kind of like a maggot with big, nasty jaws.

We'll make a narrow groove at the bottom of the jaws

When clamping force increases so does the deformation of the jaws

The jaws of it stand for a gate in the garden of Pitferren.

We de burr the jaws as necessary

Whether it's like the shark in Jaws

Now, doesn't that just torque your jaws?

When first mounting the jaws, it's a good idea to set them out as far as possible, just as a starting point

Jog to a point very close to the face of the jaws

And our program set to cut to the nominal part diameter, these jaws are ready to cut As recommended in the first video

That's an adult Orinoco crocodile in its jaws.

The jaws will deflect away from the part

For both outside holding and inside holding jaws

(Laughter) (First two notes of Jaws theme) And most of you associate that with something!

Set of characters

Set of Characters