Well, screw you twice.

You need a Robertson screwdriver.

When I turned the screw, water burst out.

lower end of the machine to maintain clearance to the coolant tank

When I turned the screw, water burst out.

Detach the panel from its mounting brackets, just as before

Again, lift the lowest side of the machine to bring it level and turn both screws an equal amount

Set each screw by tightening an additional 10 degrees

Lock the leveling screws in place

Hang the panel by aligning the drop out holes with the screws

The panel can now be lifted away from the bracket position and installed on the left side of the machine

Raise the upper enclosure frame to its extended position

Take out the coolant pump to access the middle leveling screw on this side

And tonight, you'll be able to see the device in the tent.

Pretend that you are winding me up anyway.

This is a spider mite.

He's missing screws too, screws for his heart.

Ask someone to assist you to hold the weight of the Chip Conveyor while you unfasten the Shipping Security Screws and lower the Conveyor into position

If the measurement shows there is bow in the base casting in either the up or down direction use the middle screws to make adjustments

Screws?

Screws for my heart.

I removed every screw... from this big diningroom table we had.

You need winding?

Lift the upper enclosure frame upwards slightly to meet the gussets on the side panels

You know, it's a spatula, it's a pry bar, it's a screwdriver and it's a blade, yeah.

If you don't mind, Mr Tok, I'll wind up your action.

Detach the left side panel first

This reading shows the angle of the machine front to back

Start at the operator side move to the middle of Y axis travel and then to the Column side

Check whether the LEFT FRONT leveling screw needs to be raised or lowered to bring the machine level

Each time you make an adjustment turn both leveling screws on that end an equal amount

I'll wind him up and we'll see.

I forgot to wind my watch up, so it stopped.

He moved the screws to rehang it.

Hand tighten each screw onto the puck until the puck stops turning

Repeat this step until the bubble is adjusted to zero at both ends of the Y axis travel

Standing on the lower support frame will make it easier to reach the screw holes

You can do bigger things.

leaving the machine clean with nothing left to contaminate the customer's coolant remove the screws from the shipping bracket

Once again, check that the level tool edge lines up visually with a T slot edge

He's got a screw loose.

On base castings with 6 or 8 leveling screws the middle screws should not be touching the pads during the leveling procedure

In our case, Andrew will torque the M12 bolts holding these steel jaws to 80 foot pounds

Every last bolt.

First remove the top most bracket connecting the panels to the tool changer part of the enclosure