Coolant system numbers are within tolerances.

We'll need coolant for the air support system.

Reactor coolant.

Once the Coolant Tank is full operate the Coolant System to check that none of the connections just made are leaking

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

Attach the three quarter inch Coolant Line from the Coolant Manifold to the standard Coolant Pump

Coolant level indicator

Place the standard coolant pump next and connect the 3 4 coolant line from the coolant manifold to the pump

To clear the coolant tank

Connect the electrical cord from the standard Coolant Pump to the receptacle labeled Coolant

Before attaching the Coolant Level Sensor to the Coolant Tank, check that it shows the correct

Install the Coolant Tank Handle onto the Tank

And I'm going to insert a coolant command

When all Pump connections are complete ask the customer to fill the Coolant Tank so the system can be tested for leaks

Move to the coolant pump area and attach the wash down hose assembly to the mounting point on the coolant manifold

You two get all the coolant you can carry.

I wanted to turn coolant on, I had forgotten it

And there is the coolant command inserted into the program

Take what they have. Minus the coolant which we don't need.

Maybe I forgot to turn coolant on before a particular tool

When all coolant pump connections are complete ask the customer to fill the coolant tank so the connections that were just made can be tested for leaks

leaving the machine clean with nothing remaining to contaminate the customer's coolant

lower end of the machine to maintain clearance to the coolant tank

Before attaching the coolant level sensor to the coolant tank check that it registers the correct empty, 1 2 full, and full positions on the Current Commands page

Tilt along this axis influences how coolant and chips drain from the lathe

First, the machine is positioned at the correct height above the coolant tank

In the coolant pumps. I hacked into the computer and read his notes.

system

System

System

System

System

First, the Machine is set to the correct height to clear the Coolant Tank

Now is a good time to install the Coolant Tank and its related components

Take out the coolant pump to access the middle leveling screw on this side

Make sure the machine is high enough off the ground to clear the coolant tank

System Jobs

System Settings

System Testing

system information

System Information

system notification

System Bell

System Font

System colors